SOLD OUT Ex Hire – Klark Teknik DN8000 Processor

Ex hire unit. Good working condition with hire markings on unit and some cosmetic damage.

$400

Availability: Out stock

Out of stock

Compare
Features:
A delay module – this allows delays to be set for each output, and master delays to be applied to each input. The units are selectable, and temperature compensation may be added.
A fully configurable routing module – this allows any output to be fed from either input, both inputs or neither input.
A high pass filter module – this has fully variable frequency adjustment, and a selection of roll-off (slope) and filter type combinations.
A low pass filter module – this has fully variable frequency adjustment, and a selection of roll-off (slope) and filter type combinations.
Two parametric equaliser modules – these both feature fully adjustable frequency, ‘Q’, and level, and can be placed anywhere on the frequency scale.
A ‘Low EQ’ filter module – this has variable frequency adjustment, and a selection either parametric mode or shelf mode, and level adjustment.
A ‘High EQ’ filter module – this has variable frequency adjustment, and a selection either parametric mode or shelf mode, and level adjustment.
A compressor module – this is fully featured, with adjustment available for threshold, ratio, attack, and release.
An expander module – this has adjustment for threshold, hold and release.
A limiter module – this merely has adjustment of threshold. It is a ‘zero overshoot’ design – and cannot be switched out of circuit. As such, it will not be possible to clip any of the outputs, no matter how much EQ has been added.
A phase control module – this allows the phase to be reversed (switch) and also the phase angle to be adjusted in 5° steps.
A level control module – this allows adjustment of the level of the output over a wide range.
INPUTS
TWO Balanced (electronically)
Impedance (ohm) Balanced 20K Unbalanced 10K
Common mode rejection >70dB@1KHz
Maximum Level >+21dBu
OUTPUTS
FIVE Balanced (electronically)
Min. load impedance 56 ohms//20nF
Source impedance 56 ohms
Maximum level +22dB into > 2kohms
PERFORMANCE
Frequency response +/-0.3dB (20Hz to 20KHz) With all filters and EQ flat
Distortion @ +8dBu <0.02% (20Hz to 20KHz)
Dynamic Range 114dB (20Hz to 20KHz unweighted)